Related Manuals for Rockler 27712
Summary of Contents for Rockler 27712
- Page 1 Ellipse/Circle Router Jig Instructions Effective January 2018 Review full manual instructions prior to use for important safety information. Always check Rockler.com to confirm that you are using the most recent manual version for your product.
-
Page 2: General Safety Warnings
Keep this booklet in a place where your product. To find the most recent version, find it will be readily available for reference. the product page on Rockler.com and click on the link to the Instructions. > The user assumes all risk and responsibility for the proper use of this product and for ensuring product >... - Page 3 PRODUCT SPECIFIC SAFETY WARNINGS > To avoid serious injury, keep hands and fingers away from spinning router bit. > Your router must be unplugged while attaching the > Maintain awareness of the router bit at all times Ellipse/Circle Jig and while making any adjustments. while cutting.
- Page 4 PARTS LIST - ELLIPSE/CIRCLE ROUTER JIG Quantity Jig Arm Jig Base Dovetail Key 5/16-18 x 1" Knobs 5/16" Washers 5/16-18 x 1" T-Bolts...
- Page 5 4" 4" 4" ROUTER MOUNTING HOLE KEY Porter-Cable 690/890/7529/97529/8529 series, Bosch MRC23 series, 1617-1618 seriesDeWalt 616-618, Hitachi M12VC (fixed and kit) Makita 1100, Milwaukee 5615-5624, Rigid 2930 combo kit, or routers with 6" base footprint...
- Page 6 Jig and Workpiece Setup WARNING > Properly and firmly secure your workpiece before Minor Axis attempting to make a cut. > Your router must be unplugged while attaching the Ellipse/Circle Jig and while making any adjustments. Centerpoint Major Axis We recommend using a 1/4" diameter spiral up-cut bit (82652, sold separately).
- Page 7 Locking pivot “B” Locking pivot “A” Position router bit Fig. 4 - Router removed for clarity 3. Insert a Dovetailed Key (3) into each channel in the Jig Base (2). Center one (hereafter referred to as “Dovetail Key A”) along the minor axis. The Locking Pivot closest to the router must be mounted on “Dovetail Key B”...
- Page 8 Then make the cut. Check Rockler.com for updates. If you have further questions, please contact our Technical Support Department at 1-800-260-9663 1. Mark a center point on your workpiece and lay out the or support@rockler.com...
Need help?
Do you have a question about the 27712 and is the answer not in the manual?
Questions and answers