Rockler Router Table XL Box Joint Jig Instructions

Download this manual

Congratulations on the purchase of your new Router Table XL Box Joint Jig! It securely holds larger

workpieces and allows you to cut clean 1/2" and 3/4" box joints for larger projects such as cases and

trunks. For safe and effective operation of the jig, please read the instructions fully before starting.

Router Table XL Box

Joint Jig Instructions

Need help?

Do you have a question about the Router Table XL Box Joint Jig and is the answer not in the manual?

Page 1 Router Table XL Box Joint Jig Instructions Congratulations on the purchase of your new Router Table XL Box Joint Jig! It securely holds larger workpieces and allows you to cut clean 1/2" and 3/4" box joints for larger projects such as cases and...
Page 2 PARTS LIST - RAIL COPING SLED Quantity Quantity 12 5/32"-3/4" Screw (Sliding Bracket) 1 MDF Base 2 3/4" Indexing Key 13 3-Star Knob 14 Small Washer 3 1/2" Indexing Key 15 5/32-3/4" Screw (Side Sled Bracket) 2 4 #4-3/8" Screw 5 5/16"-18 x 1/2"...
Page 3 Then lock it in place with the 5-star knobs. For best results, use Rockler’s Precision Brass Setup Bars (36918, sold separately). Fig. 4. Note: Use a test piece to be sure your settings are Fig.
Page 4 Note: The box joint finger pattern on the box’s front and back panels should be the same. The two side panels should also match. Check Rockler.com for updates. If you have further questions, please contact Fig. 8 our Technical Support Department at 1-800-260-9663 or support@rockler.com 50322 Distributed by Rockler Companies, Inc.