Related Manuals for Rockler Router Table Spline Jig
Summary of Contents for Rockler Router Table Spline Jig
- Page 1 Router Table Spline Jig Instructions Clamps have been removed for clarity. Review full manual instructions prior to use for important safety information. Always check Rockler.com to confirm that you are using the most recent manual version for your product.
-
Page 2: General Safety Warnings
This product is designed for specific applications as defined in the instructions and should not be modified and/or used for any other applications. Before using the Router Table Spline Jig, read, understand and follow all instructions and safety information provided. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. - Page 3 Jig Base Knobs for tightening Centering Gauge Right Fence Left Fence Centering Gauge shown attached to fence Sled Jig Setup 1. With the bit you will use to cut the spline slots installed in a table-mounted router, place the jig base on the router table so that the bit extends through the center opening and the expandable bars are in the miter track.
- Page 4 Cut Spline Slots 1. Determine your spline spacing. At each spline location, use a square to draw lines to locate the center of the spline slot. Make the lines at least 4 ⁄ " long so you’ll be able to see them when the workpiece is in the jig.
- Page 5 5. Turn on the router. Push the sled forward through the bit and then pull it back to rout a test slot. Fig. 5. Safety note: Keep your fingers outside the fences. Keep fingers outside the fences and away from the router bit. Failure to do so could lead to serious injury.
- Page 6 Add Fence Extensions for Narrow Stock 1. Extra support is helpful when working with narrow stock for projects such as picture frames. First, follow Steps 1-3 above to mark spline locations. 2. Cut square or rectangular extensions from flat scrap wood or sheet stock.
- Page 7 Let glue dry. 3. Trim splines flush to box sides with flush-cut saw, then sand smooth. Check Rockler.com for updates to these instrutions. If you have further questions, please contact our Technical Support Department Fig. 10 at 1-800-260-9663 or support@rockler.com...
- Page 8 59288 Distributed by Rockler Companies, Inc. Rev 06/17 ©2017 Rockler Woodworking and Hardware...
Need help?
Do you have a question about the Router Table Spline Jig and is the answer not in the manual?
Questions and answers