Drain Connection; Gravity Drain System; Drain Pump System; Connecting The Drain - Kenmore 106.89592100 Technical Education

I
I
¹⁄₄
I
I
1⁷⁄₈"
(4.8 cm)
23"
(58.4 cm)
(5 cm - 3.8 cm)
⁵⁄₁₆
Problem Solver
⁵⁄₈
Scan the code at left with your mobile device, or visit https://jennair.custhelp
recommendations that may help you avoid a service call.
¹⁄₂
Ice Maker Operation
A
B
1" (2.54 cm)
Plumbing Problems
C
D
PROBLEM
2" - 1¹⁄₂"
Ice Maker Will Not Operate
PROBLEM
Water Not Entering Drain
Properly
Ice Maker Seems Noisy

Performance Data Sheet

Model P6GEG2KL, P6KG2KL, P6WG2KL Capacity 2000 Gallons (7571
INSTALLATION ANd OperATINg INSTrucTIONS
I
I
I
I
I
I
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not remove ground prong.
Do not use an adapter. Do not use an adapter.
Do not use an extension cord.
Do not use an extension cord.
Failure to follow these instructions can result in death,
Failure to follow these instructions can result in death,
fire, or electrical shock. fire, or electrical shock.
RECOMMENDED SOLUTIONS
Check that it is plugged into a grounded 3 prong outlet.
Check that the control is turned on.
³⁄₄
Excessive Weight Hazard
Replace the fuse or reset the circuit breaker.
Use two or more people to move and install ice maker.
Use two or more people to move and install ice maker.
NOTE: If problems continue, contact an electrician.
Failure to do so can result in back or other injury.
Failure to do so can result in back or other injury.
Room temperature must be above 55°F (13°C). Otherwise, bin thermostat may se
and shut off even though the bin is not full of ice. The ice maker may not restart on
RECOMMENDED SOLUTIONS
If there was a large amount of water added to the ice maker, wait a few minutes fo
there is still water in the bin, check to see whether the drain hose is kinked.
If the drain hose is not aligned over the drain, move the ice maker to align the dra
For models with drain pumps, check that the drain hose is not damaged, or kinked
NOTE: Service technicians cannot repair plumbing problems outside of the ice m
and ice maker. Use only Whirlpool approved drain pump kit, Part Number 1901A.
plumber.
Water overflowing the reservoir is normal. This overflow helps to purge minerals th
water during the ice making process.
If there is a "whooshing" sound, check the following things:
Make sure that the water supply is hooked up and turned on.
I
Ice Maker Water Filtration System
Make sure that the drain cap is tight and the water drain pan pump is securely
I
If there is ice between the evaporator plate and the cutting grid, check that the ice
maker is level, and the problem persists, run a cleaning cycle.
WARNING
WARNING
Electrical Shock Hazard
WARNING
WARNING
Excessive Weight Hazard
n
2-11