Event, Fault And Diagnostic Trouble Codes; General Events - Stoneridge SE5000-8 Workshop Manual

Event, Fault and Diagnostic Trouble Codes

A list of all DTCs that are stored in the Stoneridge smart tachograph is presented below. A check should be made to
determine whether the DTC is still active or not. The cause of the DTC should be determined and appropriate action taken
as described in the table that follows. The Code will be seen on the Event & Fault printout as well as on the Daily printout.
The DTC will be seen on a test instrument.

General events

Code DTC
!02
!03
!04 001260
!05
!06
!07
!08 000004
002004
!09 002180
002280
002452
!0B 002B80
!0C 002D80
Type of event
or fault
Card conflict An invalid card combination has been
detected. For example a company and
a workshop card.
Time overlap The last withdrawal time of the inserted
driver card, as read from the inserted
card, is later than the UTC time of the
tachograph.
Driving without an Driving without a valid card or with an
appropriate card invalid card combination.
Card inserted while A tachograph card is inserted in any
driving slot while driving.
Last card session not The card (inserted in slot 1 or 2) has
correctly closed been withdrawn before all relevant
data have been stored on the card. It is
caused at withdrawal but detected at
the next insertion.
Overspeeding The speed of the vehicle has exceeded
the highest speed allowed for the
vehicle. This has been active during at
least 60 seconds.
Power supply The power supply to the tachograph
interruption (VU) has been interrupted for more than
200 milliseconds. The event is not
generated in calibration mode.
Power supply Power supply to motion sensor has
interruption (MS) been interrupted for more than 200
ms.
Motion data error
Motion sensor data incorrect.
(No CNTR)
Tachograph receives speed value from
motion sensor without receiving any
pulses.
Motion data error
Motion sensor data incorrect.
(CNTR)
Tachograph receives speed counter
value from motion sensor that differs
from value calculated by the
tachograph.
Motion data error Motion data incorrect. Tachograph
(Event) signature mismatch.
Time conflict (GNSS Internal and GNSS clock differs more
versus VU internal than 1 minute at 12 hours after time
clock) settings
Communication error VU cannot communicate properly with
with the remote the DSRC-VU facility
communication facility
Event, Fault and Diagnostic Trouble Codes
Description Suggested action to be taken
Withdraw the offending card.
Check the UTC time of the tachograph.
Wait for the overlap period to elapse.
If UTC time differs more than 20 minutes, a
calibration has to be performed.
Stop and insert a valid card and/or remove
inappropriate card.
No further action required.
No further action required.
Get information on the maximum speed
allowed is for the vehicle.
Check the vehicle and tachograph power
supply levels.
Check the power supply cables.
Check the vehicle and motion sensor power
supply levels.
Check the motion sensor operation and all
the wiring, replace the sensor if faulty.
Check motion sensor operation and all
wiring.
Check for evidence of tampering.
Pair the motion sensor and tachograph
again.
Perform a new calibration of the
tachograph system.
Replace the sensor if found faulty.
Check internal clock setting.
Check GNSS received clock.
Check the remote DSRC-VU unit
Check cabling to DSRC-VU facility
- 47 -