Editing Parameters; Figure 4-17 Receiving Agency Selection Window; Figure 4-18 Edit Window - Hitachi J.NET User Manual

4. Operation

4.2.3 Editing parameters

Function: Chooses editing of the module system information, editing NET1 information, or editing NET2
information.
Operation: The following describes the operation procedure.
(1) In the main window (Figure 4-8), select the desired module from the Module selection area, and then
click the Edit Parameter button.
In online mode, if a J.NET module is mounted and CPU module parameters are set, the Receiving
agency selection window (Figure 4-17) appears.
In this window, select the CPU module or option (J.NET module) from which parameters are to be read,
and then click the OK button. If a J.NET module is not mounted or if CPU module parameters are not
set, the Receiving agency selection window does not appear. In this case, parameters will be read from
the J.NET module or CPU module that is automatically selected.
(2) The Edit window (Figure 4-18) appears.
<Note>
The radio buttons in the Module selection area can be selected only when a module is mounted or a
parameter of the appropriate module is set to the CPU module.
If no module is mounted and the CPU module is not set with any parameter, you cannot edit parameters
online. Editing parameters online is enabled when a module is mounted or after a parameter that is edited
offline is sent by using the data transmission/reception function of BASE SYSTEM/S10VE.

Figure 4-17 Receiving agency selection window

Figure 4-18 Edit window

4-20