Table of Contents
Advertisement
● Until the PCs are reset, the parameters written to the CPU modules do not take effect. If you do not
reset the PCs, or if reset of the PCs fails, manually reset the PCs, or perform a power-on reset.
● Set the PCs number of the S10VE you want to configure. If the S10VE does not match the PCs number,
configuration information that is edited offline cannot be sent by the data transmission/reception
function of BASE SYSTEM/S10VE. Setting 9999 as the PCs number enables transmission regardless
of the PCs number of the S10VE. However, note that it becomes impossible to check transmission to
unintended PCs.
● Station error information remains even after normal communication is restored. The error information is
cleared after the PCs are reset or after a power-on reset is performed.
Notice
S-8
(See page 4-29.)
(See page 4-31.)
(See page 4-35.)
Advertisement
Table of Contents
