Husqvarna 123HD60 Workshop Manual page 34

5
32
Cutting deck
Remove the circlip and pull the crank rod
over the eccentric cam.
531 00 92-05
Remove the circlip and pull the crank rod
over the eccentric cam.
See chapter entitled "Centrifugal clutch"
for information on the small gear wheel .
Assembly
Clean and inspect all components for
wear and damage.
Assemble in the reverse order as set out
for dismantling.
NOTE!
Make sure that the 4 screws holding
the cutting knives together are not
tightened too much so that the
knives or not locked and can move
freely .
Fill the gear housing with grease. no. 531
00 92-05.
Lubricate the friction surfaces of the cut-
ters.