Husqvarna 123HD60 Workshop Manual page 32

5
30
Cutting deck
Cutting deck
Dismantling
Disconnect the throttle cable and sepa-
rate the connections on the short-circuit
cables.
Remove the screws holding the engine to
the vibrational dampers.
Lift out the engine.
Remove the cutting deck from the engine.
502 50 23-01
Remove the knife protector, cutting knives
and the cover over the gear housing.
505 38 13-08
Cutting deck
Dismantling
Unhook the throttle cable from the carbu-
rettor and separate the connections to the
short-circuit cable.
Remove the 4 screws holding the engine
to the vibrational dampers.
Lift out the engine and the fi tted cutting
deck.
Remove the three screws (A) and lift out
the cutting deck from the engine.
Remove the 4 screws (A) holding together
the cutting knives, the bar and the knife
protector (remove the nuts fi rst).
Remove the 7 screws and lift off the cover
(B).