Advertisement
ELECTRICAL RATINGS
Siemens Industry, Inc.
Building Technologies Division
The SSD must be installed in a dry, protected environment only.
Feed the field wiring from the double gang or 4 inch switchbox through the opening
in the mounting plate. Secure the mounting plate to the switchbox with screws (user
supplied).
Make the wiring connections to the mounting plate as shown in Figure 6.
Connect the supplied 8-pin cable from P1 on the mounting plate to P1 on the back of
the SSD Assembly. Align the standards in the four corners of the mounting plate with
the standards in the four corners of the SSD Assembly. Secure with the screws
provided.
Peel off the backing on the self-adhesive strip on the back of the overlay that is
located just below the cutout for the display. Insert the 3 bottom tabs on the appro-
priate overlay with the 3 corresponding slots in the bottom of the SSD Assembly.
Slightly bend the overlay to align and insert the 3 top tabs into the 3 corresponding
slots in the top of the SSD Assembly. Press the overlay to the SSD assembly just
beneath the cutout for the SSD display so that the adhesive from the strip on the
overlay adheres to the SSD assembly. Discard the remaining overlays, if applicable.
Be sure to route field wiring away from sharp projections, corners and internal
components of the SSD.
T
p y
c i
l a
n I
p
t u
V
o
a t l
g
e
An auxiliary regulated power-limited power supply may be used to provide power to
the SSD. The power supply must be UL approved for Fire Protection Signaling
Application.
2
0
0
m
A
(
m
a
) . x
t a
2
4
V
D
C
2
4
V
D
C
N (
o
m
n i
a
) l
3 (
1
V
D
C
m
a
) . x
i f
e t l
e r
d
8
P/N 315-034170-13
Advertisement
