Pump Operation; Heating Reset - Bestway LAY-Z-SPA VEGAS Owner's Manual

PUMP OPERATION

Heating Reset

When using the Lay-Z-Spa for first time, or
after a long period of inactivity, be sure to
press the reset button on the pump using a
small and thin object.
RESET BUTTON
IMPORTANT INSTRUCTIONS FOR USING
If the temperature on the control panel (or the water
temperature) has not changed 4-5 hours after activation of the
heating system, use a thin object to press the RESET
BUTTON, and restart the heating system.
IMPORTANT: The heating System will not operate if the
outside temperature is above 40ºC(104 ºF) or if the Lay-Z-Spa
is under direct sunlight. Under these conditions, please wait
until a cooler time of day before pressing the RESET BUTTON
with a thin object and restart the heating System.
A
Lock/Unlock Button
The pump has a 5-minute auto-lock. To lock or unlock the
pump, place a finger over the lock/unlock button for 3
seconds.
B
Temperature Adjustment Buttons
Pressing the Temperature Increase or Decrease buttons will cause the LED to
flash. When flashing you can adjust to the desired temperature setting. If you
hold these buttons down the values will rapidly increase or decrease. The new
and desired temperature setting will remain on the LED display for 5 seconds to confirm the
new value.
NOTE: The default temperature is 40°C (104°F).
NOTE: Temperature adjustment ranges from
20°C (68°F) to 40°C (104°F).
C
Heat Button
Use this button to activate the heating system.
The pump will heat the spa water until the water
temperature reaches 1°C (1.8°F) higher than the
set temperature. After the current water temperature drops 2°C
(3.6°F) below the set temperature the heating system will
restart. When the light above the heat button is red, the heating
system is activated. When the light is green, the water is at the
set temperature and the heating system is at rest.
The heating system is capable of increasing the water
temperature by approximately 1.5 to 2ºC (3-4ºF) per hour for
#54112, #54123, #54129 and 1-1.5ºC (2-3ºF) per hour for
#54113.
NOTE: If the heating system is activated
the filtration system will automatically start.
NOTE: After turning off the heating system
the filtration system will continue to
operate.
NOTE: The Lay-Z-Massage System will
automatically shutoff when the heater is
activated.
RESET
A
B
C
D
Celsius/Fahrenheit Toggle
The temperature can be displayed in either
Fahrenheit or Celsius.
NOTE: The system's
default is Celsius.
E
Water Filter Button
This button turns the filter pump on and off.
The light above the Water Filter Button displays red
when activated.
F
Lay-Z-Massage System Button
Use this button to activate the massage system,
which has a 30-minute auto-shutoff feature. The light
above the Lay-Z-Massage System Button displays
red when activated.
WARNING: Do not run the
Lay-Z-Massage system when the
cover is attached, air can accumulate
inside the spa and cause irreparable
damage and bodily harm.
18
H
Test
D E
G
F
S-S-002097