CONTENTS 1. Safety Instructions ....5. Maintenance ....... Maintaining Spa Water 2. Specifications ......For Filter Cartridge Cleaning & Replacement For Water Balance 3. Installation Instructions ... Fasten the Air-Valve Selected Location Draining the Spa Pump Test Cleaning the Spa Assembly Spa Repair Lay-Z-Spa Storage...
Page 6
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Page 7
NOTE: • Please examine equipment before use. Notify Bestway at the customer service address listed on this manual for any damaged or missing parts at the time of purchase. Verify that the equipment components represent the models that you had intended to purchase.
Page 8
SPECIFICATIONS FOR LAY-Z-SPA™ VEGAS (#54112) Capacity: 4-6 Adults Massaging Turbo Increased Heat Approximately 800W Blower: Rate: 1.5-2ºC/h (3-4ºF/h) Water Capacity (80%): 848 L (224 gal) Heat Element: 2,000W at 20ºC Actual Water Flow: 1,325 L/h (350 gal/h) Inflated Size: 1.96m x 61cm Pump: 50W Circulation 220-240V AC,...
Page 9
Part N. Part Code Description 54113TASS15 Pool P4D055ASS15 Heater P5D288ASS13 Top Leatheroid Cover 54113GASS15 Inflatable Part Top Cover P6931 Inflation Hose P6653 Filter Set 58210S10 Chemical Floater P3039 High Pressure Hand Pump F6H189 Wrench P6575 Stoppers P6932 Hose Adapter P6608 Pressure Gauge P6611 Cover Adapter A...
Page 10
Part N. Part Code Description 54123TASS15 Pool P4H054ASS15 Heater P5C364ASS14 Top Reinforce Cover 54123GASS15 Inflatable Part Top Cover P6613 Inflation Hose P6653 Filter Set 58210S10 Chemical Floater P6575 Stoppers P6932 Hose Adapter F4024ASS Screw Valve P6611 Cover Adapter A SPECIFICATIONS FOR LAY-Z-SPA™ PALM SPRINGS (#54129) Approximately Capacity: 4-6 Adults...
Part N. Part Code Description 54129TASS15 Pool P4B079ASS15 Heater P5B401ASS15 Top Leatheroid Cover 54129GASS15 Inflatable Part Top Cover P6930 Inflation Hose P6653 Filter Set 58210S10 Chemical Floater 58321(H) S15 Ground mat F6H189 Wrench P6575 Stoppers P6H565 Hose Adapter P6933 Pressure Gauge P6611 Cover Adapter A P6H971...
Pump Test 1. Insert the plug into a mains socket. The LED Test automatically displays current water temperature. 2. Press the “Test” button. All the indicator lights turn Test off, and the pump gives a warning beep. 3. Unplug and then plug the pump back in to start the system.
Page 13
Connect the pump to the spa by Remove the two stopper caps from Screw the filter set to the inside of the lining up the letters (A to A, B to B the inside of the spa’s inlet and spa’s outlet pipe. NOTE: Must screw in and C to C).
Page 14
NOTE: Pressure Inflate the spa wall. gauge is for inflation purpose only, and the value of the pressure gauge is just for reference, should not Unscrew the be used as a precision air-valve on the Ensure that the inner spring valve is not depressed. (If depressed, press spa wall.
Page 15
To heat the water, put the cover on, lock the clips, and push the heat button (see page 18). WARNING: Do not run the Lay-Z-Massage system when the cover is attached. Air can accumulate inside the spa and cause irreparable damage and bodily harm. WARNING: This spa cover is not a safety cover and is not a substitute for adult supervision;...
Page 16
Connect the pump to the spa by Remove the two stopper caps from Screw the filter set to the inside of lining up the letters (A to A, B to B the inside of the spa’s inlet and the spa’s outlet pipe. NOTE: Must screw in and C to C).
Page 17
NOTE: Before use the NOTE: Do Lay-Z-Spa Palm not use an air Springs, always make compressor sure that all of the to inflate the inflatable chambers are pool. properly inflated and Unscrew the Ensure that the inner spring valve is Use the inflation hose to air-valve on the not depressed.(if depressed, press...
PUMP OPERATION Heating Reset RESET When using the Lay-Z-Spa for first time, or after a long period of inactivity, be sure to press the reset button on the pump using a small and thin object. RESET BUTTON IMPORTANT INSTRUCTIONS FOR USING Test If the temperature on the control panel (or the water temperature) has not changed 4-5 hours after activation of the...
2. The water flow sensors are broken 2. Contact your local Bestway After Sales service point to get instructions heat button. 1. Remove the 2 stopper caps before heating, refer to Assembly section in 1.
1. Unplug the pump. 2. Remove the filter set from the spa. 3. The filter cartridge can be rinsed off with a garden hose and reused. However, if the filter cartridge remains soiled and discolored, the filter cartridge should be replaced. It is recommended to replace filter cartridge every three days depending on use. 4.
Remove the filter set from Insert the 2 stopper caps Disconnect the Screw the adapter the spa. onto the spa’s inlet and pump from the spa. cover onto adapter A of outlet pipes. the spa. Connect the hose With your hose Once most of the spa For #54112, #54123: Unscrew adapter to your garden...
Bestway strives to provide the most trouble-free spas on the market. If you experience any problems whatsover, do not hesitate to contact Bestway or your authorized dealer. Here are some helpful tips to help you to diagnose and rectify some common sources of trouble.
Page 26
E-mail: info@bestway-shanghai.com E-mail: info@bestway-hongkong.com E-mail: info@bestway-europe.com Central & South America U.S.A. Australia Bestway Central & South America Ltda Bestway (USA) Inc. Bestway Australia Pty Limited Salar Ascotan 1282, Parque Enea, 3249 E. Harbour Drive, Phoenix, Arizona 85034, Unit 10/71-83 Asquith Street,...
Need help?
Do you have a question about the LAY-Z-SPA VEGAS and is the answer not in the manual?
Questions and answers