Configuring The Remote Control Channel Id; Configuring The Remote To Control A Recording Device - Polycom HDX Series Administrator's Manual

Administrator's Guide for Polycom HDX Systems

Configuring the Remote Control Channel ID

Configuring the Remote to Control a Recording Device

10 - 2
You can configure the Channel ID so that the remote control affects only one
Polycom HDX system, even if there are other systems in the same room.
To configure the channel ID for a Polycom HDX system and remote control:
1. Go to Admin Settings > General Settings > System Settings > Remote
Control.
2. Set the Channel ID.
3. While blocking the IR signal on the remote control, press and hold the
Option button for 5 seconds.
4. Press once to Set ID.
5. Press the right arrow to change the setting.
6. Press or
system.
7. Press to select the new setting.
You can program the Polycom HDX system remote control to control a specific
recording or playback device such as a VCR or DVD player.
For a list of codes, refer to Appendix D,
Device Buttons.
To program the remote to control a recording device:
1. Press and hold the
2. Press the right arrow to select Set Code.
3. Enter the four-digit code for your recording device.
4. Press to select the new setting.
to select the channel ID that you configured on the
Codes for Remote Control Recording
Option button for 5 seconds.