Registering The Lyric Control - Honeywell Lyric Programming Manual

Lyric Controller Programming Guide
Communications Diagnostics (Continued)
Registering the Lyric Controller
Register the communications module through the AlarmNet 360 website.
The following information available should be available when programming the device:
• Primary City ID (two-digit number)
• Primary Central Station ID (two-digit hexadecimal number)
• Primary Subscriber ID (four-digit number)
• MAC ID and MAC CRC number (located on the outside of the box and on label inside module).
Note: Data must be transferred to the module, and it must be registered. Registration can take up to five
minutes to complete.
Step
1. Log on to the AlarmNet 360
2.
Log in and follow the on-screen prompts. If you are not signed up for this service, click on "Dealer
Signup" from the login screen to gain access to the Honeywell web-based programming.
Dealer Sign-Up Direct Link:
https://services.alarmnet.com/AlarmNetDirectp_signup/Submission_Agree.aspx
3.
You will be instructed how to proceed upon completing the sign-up form. Only one sign-up per
dealer is required. Once an initial user is established, additional logins may be created by that user.
4
Once the module has registered, log out of the AlarmNet 360 website.
Checking Signal Strength
When choosing a suitable mounting location, check the communications module's signal strength to ensure
proper operation. For most installations, using the module's internal antenna, mounting the Lyric controller as
high as practical, and avoiding large metal components provides adequate signal strength for proper operation.
To check signal strength, perform the following test.
Check Signal Strength
1. With the System in the Installer Programming mode,
select the "Comm. Diagnostics" button and then select
the "Cellular Information" button. The Cellular
Information will be displayed. The signal strength is
displayed (in dBm) as RSCP if the Lyric-3G module is
operating on the 3G Network or RSSI if the module
Lyric-3G module is operating on the 2G Network and
for the Lyric-CDMA module.
2. Compare the displayed RSCP or RSSI number to the
correct Signal Strength Guide at right to ensure
adequate signal strength. If necessary, relocate the
Controller to obtain better signal strength (select
"Cellular Information" again to refresh the reading).
3. If adequate signal strength cannot be achieved,
External Antenna Kit model Cell-ANTST should be used.
Action
TM
website. Go to: http://alarmNet360.com
- 28 -
Lyric -3G Signal Strength
RSCP (3G)
Good .................. -20 to -90 dBm
OK ....................... -91 to -100 dBm
Marginal ............ -101 to -106 dBm
Bad ..................... -107 to -120 dBm
RSSI (2G)
Good .................... -20 to -89 dBm
OK ......................... -90 to -98 dBm
Marginal .............. -99 to -104 dBm
Bad ....................... -105 to -120 dBm
Lyric -CDMA Signal Strength
RSSI
Good .................... -20 to -90 dBm
OK ......................... -91 to -100 dBm
Marginal .............. -101 to -106 dBm
Bad ....................... -107 to -120 dBm