Cooling - Fresh Water System, Keel Cooling, Heat Exchanger - Beta Marine Beta 10 Operator's Maintenance Manual

COOLING
The Mini Series range of engines are
normally fresh water cooled. This
water circulates through the engine
and on to a heat exchanger where it
is cooled by sea water which is
pumped through the cooling tubes.
The sea water is then injected into
the exhaust system (see diagram
'heat exchanger cooled' below).
Heat Exchanger Cooled
FILLING THE FRESHWATER SYSTEM
New engines are supplied with the
freshwater drained off. The following
instructions must be followed to fill
the system.
(a) Mix up in a clean bucket a 30 to
50% antifreeze to freshwater
solution. For the volume required
see technical specification page 4.
(b) Check that the drain tap or plug
is turned off. (see fig 2l) (Note
BZ482 and B10 engines with
sump drain pump are fitted with
a plug).
(c) Fill engine with freshwater/anti
freeze solution through the top of
the heat exchanger or header
tank with the filler cap removed.
(see fig 2m).
(d) Fill header tank to the top of the
filler neck and replace cap. Press
KEEL COOLING is an option. In this
system the freshwater is pumped
through the engine and then through
a cooler built into the side of the boat
where it is cooled by heat transfer
before returning to the engine .
The ideal keel cooling tank should
have:
down firmly on filler cap and
hand tighten in a clockwise
direction.
Note: For keel cooled engines a
much larger quantity of
freshwater/anti-freeze solution is
required depending on the size of the
keel cooling tank – refer to the
builder.
(e) Run the engine for 5 minutes on
no load (out of gear) and check
coolant level. Top up as
necessary.
(f) Check system for leaks.
Note: For keel cooled engines it
is very important to bleed all the
air out of the system before the
engine is run on load (check with
builder's instructions).
10
a. Baffle continuously welded to
outer skin and close fitting on
inner skin
b. Be thin in section to allow good
mixing of the water over the cool
outer surface.
c. Air bleed valves should be fitted
on both ends. (See page 30).
Keel Cooled -Note efficient cooling tanks are side
mounted, see page 31
(g) If a calorifier is fitted care must
be taken to see that this is also
full of coolant and all the air is
expelled. (See calorifier fitting
notes under Section 3).
(h) Run the engine on one third load
for 15 minutes, preferably with
the boat tied up. As the system
warms up coolant may be
expelled from the overflow pipe
into the bilge. Stop the engine
and allow the engine to cool
down before removing the
pressure cap and top up the
coolant to 1" below the filler
neck.