Table of Contents
Advertisement
Chapter 4 Maintenance Mode Functions
–
–
7. To require users to enter this password when they swipe a Maintenance badge,
enable Require Password with Badge.
8. Tap Save Settings.
Change Database Password
Use the Change Database Password function to change the password for a
database.
1. Tap Edit Advanced Settings.
2. Tap Change Database Password.
3. Enter the new password, which must be eight characters in length, and contain
at least one of each of the following: uppercase letter, lowercase letter,
number, and special character. Tap Enter.
4. Re-enter the new password and tap Enter.
5. Tap Save Settings.
Factory Defaults
Use Factory Default to restore the device settings to the factory default settings.
Caution: Use the Factory Default settings only if the timeclock is not operating
properly. You lose all previous settings and data when you perform this function.
1. Tap Edit Advanced Settings.
2. Tap Factory Defaults.
3. To confirm your selection, tap Restore. The timeclock reboots.
118
Strong
Weak
- Quick Links:
- Initial Setup and Configuration
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the InTouch DX and is the answer not in the manual?
Questions and answers
only thing on screen is maintenance and clean screen, it says password incorrect, is there a way to restart the setup
To restart the setup on a Kronos InTouch DX when the screen shows "maintenance" and "clean screen" with a password incorrect message, follow these steps:
1. If the device is unresponsive or stuck, reboot it using the restart button on the main board.
2. Open the device’s cover using the security wrench that came with the device.
3. Locate the restart button on the main board (inside the cover).
4. Press and hold the restart button for four seconds.
This will reboot the device and allow you to start the setup again.
This answer is automatically generated