Table of Contents
Advertisement
Clean Cab Floor (ZX26U-5A) (Cab equipped machine)
--- as required
IMPORTANT: Only the cab floor can be washed with
water. Take care not to splash other parts of the cab
with water. Do not increase the water pressure speed
by squeezing the hose end. Never use steam to clean
the cab floor. Always clean the cab floor only after
closing duct (1) to prevent water from entering the
duct.
If water enters the duct, the heater may be damaged.
Also, if water falls on the box under the seat, internal
electrical parts may be damaged.
1. Park the machine following the same procedures as
described on page 7-7 for preparation for inspection and
maintenance.
2. Sweep the cab floor clean using a brush, and brush dust
from the cab floor while spraying water. (Sweep out the
mud and dust with a brush as much as possible before
applying water.)
3. When cleaning the floor mat, sweep dust (water) along
the grooves on the floor mat.
4. When cleaning the cab floor with the floor mat removed,
remove only rear mat. Then sweep the dust and/or water
through one cleaning hole.
When water penetrates, operate the fan at the maximum air
volume for several minutes to dry water.
Turn the heater OFF at this time.
MAINTENANCE
7-82
1
MABA-01-012
Advertisement
Table of Contents
