Philips Eclipce HQ4441/A Service Manual

Service
Service
Service
Domestic Appliances and Personal Care
HINTS FOR REPAIRS
a. Disassembly
- Remove shaving unit, to prevent damages
during a repair.
- Remove the screws A1 (4x).
- Put the shaver on the table and remove the cover
from the shaver.
- Pull the connection leads out of the terminals on the
bearing block of the motor and remove the p.c.-board.
- Loosen the motor clamping springs on the bearing
block with a small screwdriver.
-
Remove the motor.
-
Remove the screws A2 (2x)
-
Unlock the peg clamping (3x) between frame and
hair chamber.
-
Remove the gearwheels and trimmer drive.
-
To remove the trimmer, first disassemble the trimmer
slide by pushing down the locking pegs (4x "X" in
exploded view) and move the slide slightly outwards.
-
Make room between trimmer and cover with a small
screwdriver ("Y" in exploded view).
b. Assembly
- The assembly must be carried out in reverse order
of what is described under a. Disassembly.
CAUTION!
WHILE CHECKING THE P.C.-BOARD REMEMBER
THAT MOST COMPONENTS AND THE MOTOR
ARE ENERGIZED BY MAINS VOLTAGE.
Published by Philips Domestic Appliances and Personal Care
4322 277 00182
00/01
SK1
R1
100-240 V
D1 D4
16 15
1
4852
4853
TECHNICAL DATA
Voltage
Power consumption
Motor voltage
Power supply
Shaving heads
Comfort control
SAP coding
©
Printed in The Netherlands Copyright reserved
Mains Shaver
L1
C1 C2
R1
D5
R2
14 13 12 11 10 9
R5
IC1 L2
2 3 4 5 6 7 8
R3 C3
: 100-240 V 50/60Hz
: Motor depending
: 54 V
: SMPS
: HQ4 - 4822 690 30468
: fixed setting
: HQ4441
Subject to modification
C4
M