Canon 2/3 Hole Puncher Unit-A1 Service Manual page 63

7. Remove a Screw.
NOTE:
Removed screw is used in step 8.
1x
8. Install the Punch Unit Open / Close Guide.
• 2 Screws (TP ; M3x6)
• 1 Boss
NOTE:
Use screws removed in step 6 and 7.
2x
Boss
9. Install the Punch Waste Full Sensor Unit.
• 1 Screw (TP ; M3x6)
NOTE:
Use the screw removed in step 3 of Unpacking Procedure.
1x
10. Cut out the face cover of the Inner Cover by using
the side cutter.
CAUTION:
Be sure to remove the face cover thoroughly so that no
burr of the Inner Cover is remained.
57
6. Installation