Canon 2/3 Hole Puncher Unit-A1 Service Manual page 62

4. Remove the Inlet Feed Guide.
• 1 Screw
• 1 Connector
• 1 Wire saddle
• 2 Harness guides
1x
3x
1x
TP (M3x6)
5. Install the Punch Unit Fixing Pin Holder.
• 1 Screw (TP ; M3x6)
1x
NOTE:
Use the screw removed in step 3 of Unpacking procedure.
6. Remove the Magnet Unit.
• 1 Screw
NOTE:
Removed screw is used in step 8.
1x
56
6. Installation