Storage; Cleaning And Storage - Toro 30187 Operator's Manual

Mid-size t-bar hydro, 15hp traction unit
Hide thumbs Also See for 30187:
Table of Contents

Advertisement

Storage

Cleaning and Storage

1. Disengage the power take off (PTO) and turn
the ignition key to off. Remove the key.
2. Remove grass clippings, dirt, and grime from
the external parts of the entire machine,
especially the engine. Clean dirt and chaff from
the outside of the engine's cylinder head fins
and blower housing.
Important: You can wash the machine
with mild detergent and water. Do
not pressure wash the machine. Avoid
excessive use of water, especially near the
shift lever plate, and engine.
3. Service the air cleaner; refer to Servicing the
Air Cleaner in Engine Maintenance, page 25.
4. Change the crankcase oil; refer to Servicing the
Engine in Engine Maintenance, page 25.
5. Check the tire pressure; refer to Checking the
Tire Pressure in Drive System Maintenance,
page 33.
6. For long-term storage (more than 90 days) add
stabilizer/conditioner additive to fuel in the
tank.
A. Run engine to distribute conditioned fuel
through the fuel system (5 minutes).
B. Stop engine, allow to cool and drain the
fuel tank; refer to Servicing the Fuel Tank
in Fuel System Maintenance, page 29, or
operate engine until it stops.
C. Restart engine and run until it stops.
Repeat, on Choke until engine will not
restart.
D. Dispose of fuel properly. Recycle as per
local codes.
Note: Do not store stabilizer/conditioned
gasoline over 90 days.
7. Remove the spark plug(s) and check its
condition; refer to Servicing the Spark Plug in
Engine Maintenance, page 25. With the spark
plug(s) removed from the engine, pour two
tablespoons of engine oil into the spark plug
hole. Now use the starter to crank the engine
and distribute the oil inside the cylinder. Install
the spark plug(s). Do not install the wire on
the spark plug(s).
8. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged or
defective.
9. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service
Dealer.
10. Store the machine in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it in a memorable place. Cover
the machine to protect it and keep it clean.
39

Advertisement

Table of Contents
loading

Table of Contents