Adjusting The Tracking; Installing The Battery - Toro 30187 Operator's Manual

Figure 6
1. Control rod
2. Control bracket
3. Hairpin cotter pin
Step
5

Adjusting the Tracking

No Parts Required
Procedure
1. After completing the setup, check the machine
tracking. Operate the machine by holding the
upper control bar against the reference bar
with the wheels engaged.
2. If the machine does not track straight,
adjustment is required.
3. Loosen the wing nut on right control rod and
rotate the turnbuckle in or out to change the
tracking. Secure the turnbuckle in position
with the wing nut (Figure 5).
4. Check for proper tracking.
Note: The control rod must be adjusted if
the handle height position is changed.
4. Wing nut
5. Turnbuckle
Step
6

Installing the Battery

Parts needed for this step:
1 Battery
2 Battery holder bracket
2 Battery pad
1 Battery strap
2 Battery support rod
2 Terminal boot
2 Bolt, (3/8 x 1-3/4 inches)
2
Locknut, (3/8 inch)
2 Carriage bolt, (1/4 x 3/4 inch)
2
Locknut, (1/4 inch)
2 Nut, (1/4 inch)
Procedure
Bulk electrolyte with 1.265 specific gravity must be
purchased from a local battery supply outlet.
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to the State of
California to cause cancer and reproductive
harm. Wash hands after handling.
Battery electrolyte contains sulfuric acid
which is a deadly poison and causes severe
burns.
Do not drink electrolyte and avoid contact
with skin, eyes or clothing. Wear safety
glasses to shield your eyes and rubber gloves
to protect your hands.
Fill the battery where clean water is always
available for flushing the skin.
Follow all instructions and comply with all
safety messages on the electrolyte container.
13