Toro 03857 Operator's Manual page 17

bedknife.
NOTE: The second screw height was determined in
section B: Setting Cutting Unit Attitude.
1
2
1. 1stscrew
2. 2nd screw
3. If there is a gap between the rear roller and the
gauge bar, or if the rear roller will not let you put
the gauge bar on the bedknife, proceed as follows:
4. Loosen the lock nuts on the rear side brackets
(Fig. 24).
Figure 23
1. Locknut (both sides)
5. To reduce thread play, turn the rear adjusting screw
clockwise until a slight gap exists between the rear
roller and gauge bar. Then turn the rear adjusting
screw counterclockwise until the rear roller contacts
the gauge bar. After adjustment, verify that the
gauge bar contacts the rear roller on both ends of
the bedknife.
NOTE: Make sure the gauge bar is in contact with
the front roller at all times to keep correct cutting
unit attitude.
6. Slide the gauge bar toward the end of the cutting
unit to remove it. The gauge bar can now be useed
to set the remaining cutting units on the machine.
Setting Height of Cut
1
Figure 24
17