Toro 03857 Operator's Manual page 12

Setting Height of Cut
TABLE 1—NEW CUTTING UNIT SET-UP GUIDE
Rear Support
Desired Height Bracket Hole
Desired 2nd Screw "A" Front Roller Side Plate
of Cut (Fig. 12)
Attitude (Fig. 14) "B" (Fig. 11)
Hole (fig. 11)
•Optional Low-Cut Bedknife, Toro part no. 93-9774, is required for a height of cut below 13mm
NOTE: For front roller distances ("B") greater than 38 mm, switch the long and short adjusting nut locations for
better support (fig. 11)
12