Advertisement
Available languages
Available languages
How to use the iron
1
Temperature settings
Steam
„
z
Press the SET / OFF button to set the temperature according to the fabric you are ironing.
z
z
The temperature lamp flashes. (See page 7)
Shower Steam, Ultra shot, and Hanger shot
„
z
Press the SET / OFF button to set the [HIGH] temperature setting.
z
z
The temperature lamp flashes.
If you set any temperature other than [HIGH], water may leak out and Shot may not work.
Shower Steam is for
finishing thick fabrics
or wool
2
Getting started
You can use the iron when the temperature lamp stops
(When you take the iron off the stand, the temperature lamp turns off.)
Set the Steam / Dry lever to [
z
z
Attention
If the iron is set to [LOW] or [MED], always set the Steam / Dry lever to [
z
z
If the steam does not come out very well, press the Shot button
z
z
If you are ironing a blended fiber, set the temperature according to the lower temperature fiber.
z
z
Drops of water may adhere to the surfaces of the iron and the water tank when steam comes out. Wipe off the drops of water if too
z
z
many water drops collect.
Notice
When you put the iron back on the stand, it may make a hissing noise and steam may come out of the soleplate, but this is not
z
z
abnormal. (This is because the water left in the channels within the iron is slowly vaporizing.)
When you first turn on the power, the iron may emit a slight smell and some smoke, but this will go away as you use it.
z
z
flashing
Steam] or [
Shower].
Flashing
lit
Stays
when it reaches the set temperature.
8
Steam ironing
According to fabric
Always in [HIGH]
lit
and stays
.
Lighting
Steam].
several times to do a steam shot.
Advertisement
