Advertisement
Available languages
Available languages
Getting ready to use the iron
1
Remove the case
Hold the open buttons on both
sides of the case, pull them both
outward (
) as the arrows show,
and then lift up (
).
②
①
②
①
Attention
Dirt on the soleplate may stain clothing. Clean the soleplate before using the iron.
z
z
When carrying the water tank, set the Steam / Dry lever to [
z
z
Wipe water off if it adheres anywhere other than the fill opening.
z
z
Do not put water past the full mark. Steam will come out of the iron when it is placed on the stand.
z
z
Do not put the case on while the power plug is plugged into an electrical outlet.
z
z
Useful functions
Auto power off function (in case you forget)
If you leave the iron on the stand for more than about 10 minutes, the power is automatically turned [OFF]
(temperature lamp turns off).
To restart the power
2
Put water (add more water)
If you are using the iron for dry ironing, you do not
need to put water.
1
Put the Steam / Dry lever in the [
remove the water tank. (See page 6)
2
Put tap water up to the full mark.
3
Close the lid of the fill opening and put the water tank on
the iron.
Up to this line
Dry], and hold the fill opening up. (Causes water leaks.)
Press the SET / OFF button and set the temperature according to the fabric you are
ironing.
5
3
Turn on the
power
Plug the stand side power plug
to the stand and the power
supply side plug to electrical
Dry] position, and
outlet.
Insert plugs all
the way!
Advertisement
