Configuring Tx Power Values And Battery Type - Motorola ASTRO 25 GTR 8000 Manual

3 In the System tree, click Hardware Configuration and complete the fields on the two tabs.
NOTICE: As part of Remote Multicoupler (RMC) configuration, you must set the DIP
switches on the RMC/Low Noise Amplifier (LNA) modules. See
Gain on page
4 In the System tree, click Options and complete the fields.
5 In the System tree, click Infrastructure Interface and complete the fields on the three tabs.
6 In the System tree, click Channel Configuration and complete the fields.
7 In the System tree, click Repeater Configuration in the System tree and complete the fields.
8 In the System tree, click Receiver Scan and complete the fields.
9 In the System tree, click Repeater Access and complete the fields.
10 In the System tree, click WildCard Tables and complete the fields on the three tabs.
11 In the System tree, click Network Services Configuration and complete the fields on the three
tabs.
NOTICE: For configuration details for RADIUS Services, see the Authentication Services
manual. For configuration details for SYSLOG Services, see the Centralized Event
Logging manual.
12 In the System tree, click Password Configuration and complete the fields.
NOTICE: Password Configuration is only required if you have passwords entered for
local accounts and sets the password complexity and controls. For details on password
complexity and controls, see "Password Configuration" in CSS Online Help.
13 From the menu, select File → Save As to save the configuration data to a new archive file, or
select File → Save to overwrite the existing archive file.
IMPORTANT: Be sure to save any configuration changes to a local or network drive so
that if the base radio fails, you can load your settings to a replacement base radio. If the
configuration file is not saved to a local or network drive, you will need to repeat the
setup steps after replacing a base radio.
14 From the menu, select File → Write Configuration to Device to write the configuration data to
the base radio.
4.4.10

Configuring Tx Power Values and Battery Type

When and where to use: As part of the site configuration process, the Battery Type, Tx Power Level
(Battery Backup), and Tx Power Out on the Hardware Configuration tab in Configuration/Service
Software (CSS) must be configured.
Procedure:
1 Connect to the device through an Ethernet port link and read the configuration file from the
device. See Connecting Through an Ethernet Port Link on page
2 From the navigation tree, select Configuration.
The Configuration window appears.
3 Select the Hardware Configuration tab.
4 In the Tx Power Out (Watts) field, enter a value.
5 In the Tx Power Level Battery Backup (Watts) field, enter a value.
154.
Chapter 4: GTR 8000 Base Radio Configuration
Setting RMC System
140.
MN003286A01-E
153