Inspecting Device Properties For Transferred And Installed Software - Motorola ASTRO 25 GTR 8000 Manual

MN003286A01-E
Chapter 3: GTR 8000 Base Radio Installation
NOTICE: Selecting nvm partition defines where the OS image is transferred and is the
only choice for the device.
13 From the Selected Image section, select the image for this device.
NOTICE: Ignore the Install and Copy check boxes.
The Image Info tab is populated and informs the application which image to use.
14 Click Add.
The Summary of Device Partitions for Device populates and confirms the proper setup.
15 Select the Device Options section, Software Operations, then choose transfer, install, or
both.
These selections indicate which operations occur when the job is executed.
NOTICE: If transfer is chosen, select the install option later to complete the installation.
If both is chosen, the software is transferred and installed. There are up to two resets of
the device during installation.
16 Click Schedule.
17 From the Schedule Push Job window, configure the schedule information. Click Approve and
Submit.
The job is approved and can be viewed in the Schedule Manager window.
NOTICE: If only Submit is chosen, the job must be approved later.
18 Verify the job status by pressing F7 (Schedule Manager).
The Schedule Manager window appears in the UNC with the discovery jobs.
3.8.3.3

Inspecting Device Properties for Transferred and Installed Software

When and where to use: When the software has been transferred and installed, follow this procedure
to inspect the device properties before assuming the installation was a success and disabling FTP
service
Procedure:
1 From the Device view, right-click the device, select Pull, and then Pull Hardware Spec.
The current software version information is updated in the Unified Network Configurator (UNC).
NOTICE: Skip this step if a Pull All or Pull Hardware Spec has already occurred.
2 From the Device view, right-click on the device, and then choose Properties.
The Device Properties window appears.
NOTICE: Select the Properties icon to view the device properties appear directly within
the Device view.
3 Choose the Configuration tab, and then the Hardware tab.
4 Double-click the Chassis object from the Physical Hardware properties.
130