Setting Css Configuration Parameters For The Gtr 8000 Base Radio (Conventional) - Motorola ASTRO 25 GTR 8000 Manual

MN003286A01-E
Chapter 4: GTR 8000 Base Radio Configuration
For configuration parameters for an HPD GTR 8000 Base Radio, see "HPD Remote/Expandable Site"
in the CSS Online Help.
Process:
1 Connect to the base radio through an Ethernet port link and then read the configuration file from
the base radio. See
2 In the System tree, click System and complete the field.
3 In the System tree, click Site and complete the fields.
4 In the System tree, click Channel and complete the fields.
5 In the System tree, click Configuration and complete the fields on all four tabs.
NOTICE: As part of Remote Multicoupler (RMC) configuration, set the DIP switches on
the RMC/Low Noise Amplifier (LNA) modules. See
154.
6 In the System tree, click Network Services Configuration and complete the fields on the three
tabs.
NOTICE: For configuration details for DNS and RADIUS Services, see the Authentication
Services manual. For configuration details for SYSLOG Services, see the Centralized
Event Logging manual.
7 In the System tree, click Password Configuration and complete the fields.
NOTICE: Password Configuration is only required if you have passwords entered for
local accounts and sets the password complexity and controls. For details on password
complexity and controls, see "Password Configuration" in CSS Online Help.
8 From the menu, select File → Save As to save the configuration data to a new archive file, or
select File → Save to overwrite the existing archive file.
IMPORTANT: Be sure to save any configuration changes to a local or network drive so
that if the base radio fails, you can load your settings to a replacement base radio. If the
configuration file is not saved to a local or network drive, you will need to repeat the
setup steps after replacing a base radio.
9 From the menu, select File → Write Configuration to Device to write the configuration data to
the base radio.
4.4.9
Setting CSS Configuration Parameters for the GTR 8000 Base Radio
(Conventional)
Prerequisites:
The Ethernet Type field for a standalone conventional base radio must be set to 10 Mbit, half-duplex.
Before proceeding with this process, complete the initial configuration of the device in
Device Configuration on page
For configuration parameters for a conventional GTR 8000 Base Radio, see the following in the CSS
Online Help:
• Analog-only, Digital-only, or Mixed Mode GTR 8000 Base Radio: Conventional Site - ASTRO
7.12 and Later
Process:
1 Connect to the base radio through an Ethernet port link and then read the configuration file from
the base radio. See
2 In the System tree, click Site and complete the fields.
152
Connecting Through an Ethernet Port Link on page
134.
Connecting Through an Ethernet Port Link on page
140.
Setting RMC System Gain on page
CSS Initial
140.