Removing And Installing Air Filter Housing - Skoda Octavia III 2013 Workshop Manual

2.2 Removing and installing air filter hous‐
ing
Removing
– Pull off air guide hose -2-.
– Pull off -1- air filter housing upwards from the ball pin.
– Loosen hose clamps -3- and -4- and remove air guide pipes.
– Grab air filter housing and remove by pulling it upwards.
Install
Note
If the air filter is heavily soiled or wet, dirt particles or moisture
♦
can enter components and distort the measured values. This
leads to loss of power as a smaller injection quantity is calcu‐
lated.
It is imperative for the air filter housing to be clean.
♦
Hose connections and air guide pipes and hoses must be free
♦
of oil and grease before being installed.
Use a silicone-free lubricant to assemble the air guide hoses.
♦
♦ Secure all hose connections with hose clamps which comply
with the series design ⇒ Electronic Catalogue of Original
Parts"ETKA."
When blowing out the air filter housing using compressed air,
♦
cover critical air-carrying components such as air ducts etc,
with a clean cloth. This will prevent any malfunctions.
Observe disposal regulations!
♦
– Remove mechanical foreign particles from the top and bottom
parts of the air filter housing.
– Clean the water drain with compressed air.
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
239
2. Air filter