Table of Contents
Advertisement
Scenario 3: Access to the Third-Party Network Through a VLAN ID Other Than 4094
Networking
The following figure shows the networking diagram in which the third-party
network is accessed through a VLAN ID other than 4094. In a microwave
network, VLAN 4094 is used for internal communication. On the port used by the
PowerCube 500 on the aggregation node to connect to the third-party network,
VLAN 4094 is converted into another VLAN ID (for example, VLAN 507). The
Webserver cannot use the NMSif IP address to access the PowerCube 500.
HUAWEI TECHNOLOGIES CO., LTD.
Third-Party Network Configuration Principles
Configure a VLANIF subinterface. The IP address of the subinterface is the PowerCube
500-3's gateway IP address, which is on the same network segment as the NMSif IP
address.
Aggregation Node Configuration Principles
1. Disable the DHCP client function on the PowerCube 500-3 on the aggregation node
and manually set the NE IP address. The NE IP address is also the gateway IP
address of the RTN510 AP.
2. The gateway IP address of the PowerCube 500-3 is the IP address of the VLAN IF
subinterface of the third-party router.
3. Implement the IP DCN protocol for the port used by the PowerCube 500-3 to connect
to the third-party network.
4. Do not configure the NMSif IP address and the NE IP address to be on the same
network segment.
5. Configure the AP as the DHCP server.
Note: After the DHCP server is enabled, the DHCP gateway IP
address is used to access the NE.
6. Set the DHCP gateway IP address to the IP address of the PowerCube 500-3 on the
upstream aggregation node.
Configuration Principles of the RTN510 RT and Downstream PowerCube 500
Enable the DHCP client function on the RTN510 RT, PowerCube 500-1, and
PowerCube 500-2. The AP at the aggregation site assigns IP addresses to them.
Note: After the DHCP client is enabled, the IP address allocated by
the DHCP server is used to access the NE.
Huawei Confidential
Page 7
Hide quick links:
Advertisement
Table of Contents
