Hitachi CS 33EDP Service Manual page 14

Engine

Hide thumbs Also See for CS 33EDP:

• Mount the Cam Plate (NS) [190] so that the pawl of the plate interlocks with the hook at the end of

spiral spring (B). Turn the Cam Plate (NS) [190] clockwise while holding the Reel (NS) [191] by hand,

and confirm that the Cam Plate (NS) [190] is rewound by spring force.

• Mounting the spiral spring (B) and Cam Plate (NS) [190]

Spiral spring (B)

Hook

• Wind the Starter Rope (NS) [186] five times around the Reel (NS) [191] by following procedure below

and referring to the photos.

(a) Rotate the Reel (NS) [191] counterclockwise and wind the Starter Rope (NS) [186] three times.

(b) Hook the Starter Rope (NS) [186] in the groove of the Reel (NS) [191]. While preventing the rope

from coming off, hold the Starter Rope (NS) [186] by hand and wind the Reel (NS) [191] clockwise

two times. Then release your hand from the Reel (NS) [191] and wind the Starter Rope (NS) [186].

If the Starter Rope (NS) [186] cannot be fully wound, wind it again as per the procedure above.

• Confirm that the Reel (NS) [191] rotates three or four times until the Starter Rope (NS) [186] is fully

pulled. If the Reel (NS) [191] rotates less than three times, replace the Starter Rope (NS) [186]. Also

confirm that the Reel (NS) [191] rotates clockwise a half turn more when the Starter Rope (NS) [186]

is fully pulled. If the reel does not rotate, release the Starter Rope (NS) [186] by one turn from the Reel

(NS) [191].

• How to wind the Starter Rope (NS) [186]

• Avoid getting Cord (A) [83] and the Cord [78] caught by the Air Deflector Ass'y [188].

• Reassembly of the Recoil Starter Ass'y (NS) [198] is made easier by first pulling the starter handle,

and then returning it a little.

Reel (NS) [191]

Cam Plate (NS) [190]

Pawl

Groove

-13-

Cs 33ed