Download Print this page
Sealey PBIW4600 Manual

Sealey PBIW4600 Manual

Schumacher 500/1500hp 12/24v wheeled roadstart emergency jump starter

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instruction
protection
manual
1. SAFETY
1.1.
GENERAL SAFETY
Modern vehicles contain extensive electronic systems. You are required to check with the vehicle manufacturer, for any
specific instructions regarding the use of this type of equipment on each vehicle.
No liability will be accepted for damage/injury, where this product is not used in accordance with all instructions.
PLEASE SAVE THIS OWNER'S mANUAL AND READ BEFORE EACH USE.
This manual will explain how to use the unit safely and effectively. Please read and follow these instructions and precautions carefully.
9
If someone else uses the Roadstart, make they are well informed on how to use it safely, and have read and understood the operating
9
instructions. The longevity of the Roadstart depends on it.
Charge the Roadstart's internal battery immediately after purchase, after each use and as often as possible. It is highly recommended
9
to leave the Roadstart permanently connected to the automatic charger.
Read the entire manual before using this product. Failure to do so could result in serious injury or death.
9
Keep out of reach of children.
9
This Roadstart is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack
9
of experience and knowledge, unless they have been given supervision or instruction concerning the use of the Roadstart by a person
responsible for their safety.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental
9
capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved.
Children shall not play with the appliance.
9
DO NOT put fingers or hands into the product.
8
DO NOT expose the Roadstart to rain or snow.
8
Use only recommended attachments. Use of an attachment not recommended or sold by Sealey may result in a risk of fire, electric
9
shock or injury to persons or damage to property.
To reduce the risk of damage to the electric plug or cord, pull by the plug rather than the cord when disconnecting the Roadstart.
9
To reduce the risk of electric shock, unplug the Roadstart charger from the outlet before attempting any maintenance or cleaning.
9
Simply turning off the controls will not reduce this risk.
DO NOT operate the Roadstart or charger with a damaged output cable; have the damaged part replaced immediately by a qualified
8
service person.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid
9
a hazard.
NEVER wait until the Roadstart is completely discharged before recharging.
8
DO NOT operate the Roadstart if it has received a sharp blow, been dropped or otherwise damaged in any way; take it to a qualified
8
service person.
DO NOT disassemble the Roadstart or charger; take it to a qualified service person when service or repair is required. Incorrect
8
reassembly may result in a risk of fire or electric shock.
RISK OF EXPLOSIVE GASES. PREVENT FLAMES AND SPARKS. PROVIDE ADEQUATE VENTILATION DURING CHARGING.
WORKING IN THE VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES
DURING NORMAL OPERATION. FOR THIS REASON, IT IS IMPORTANT THAT YOU FOLLOW THESE INSTRUCTIONS EACH
TIME YOU USE THE ROADSTART.
The Roadstart must be placed in a well-ventilated area.
9
To reduce the risk of a battery explosion, follow these instructions and those published by the battery manufacturer and the
9
manufacturer of any equipment you intend to use in the vicinity of the battery. Review the cautionary markings on these products and
on the engine.
1.2.
PERSONAL PRECAUTIONS
RISK OF EXPLOSIVE GASES. A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLOSION. TO REDUCE THE RISK
OF A SPARK NEAR THE BATTERY:
NEVER smoke or allow a spark or flame in the vicinity of a battery or engine.
9
DO NOT permit the internal battery of the Roadstart to freeze. Never charge a frozen battery.
8
© Jack Sealey Limited
SCHUMACHER 500/1500HP 12/24V WHEELED
ROADSTART® EMERGENCY JUMP STARTER
mODEL NO'S:
Wear
Do not expose
ventilated area
protective
to rain
clothing
Original Language Version
PBIW4600, PBIW6200
Keep away
Use in a well
from sparks
and flame -
battery could
emit explosive
gases
Warning!
Corrosive
substance
PBIW4600, PBIW6200 | Issue:2 (6) 04/11/19

Advertisement

loading

Summary of Contents for Sealey PBIW4600

  • Page 1 DO NOT expose the Roadstart to rain or snow. Use only recommended attachments. Use of an attachment not recommended or sold by Sealey may result in a risk of fire, electric shock or injury to persons or damage to property.
  • Page 2: Specification

    2. INTRODUCTION High performance (2x 23Ah PBIW4600, 2 x 32Ah PBIW6200) AGm battery, specially formulated to jump-start up to 1500hp diesel vehicles. Rotomolded high durability casing with lifetime warranty. Patented 4A microprocessor controlled speed charging and thermal runaway protection. Unlike other Roadstart packs, can be left safely on charge continuously. Audible warning signals if the unit has been turned on for too long without being connected to a battery and reverse polarity.
  • Page 3: Preparation For Use

    12V JUMP STARTING, fig.2 Connect the red clamp (+) to the positive terminal (+) of the battery, then connect the Black clamp (-) to the negative terminal of the battery. Original Language Version © Jack Sealey Limited PBIW4600, PBIW6200 | Issue:2 (6) 04/11/19...
  • Page 4 Disconnect the black (-) clamp first followed by the red (+) clamp. 6.1.6. DISCONNECTION OF THE VOLTAGE SELECTOR, fig.7 6.1.7. After starting disconnect the voltage selector. 6.1.8. STORAGE, fig.7 see also Section 7 6.1.9. Return the clamps to their support posts. 6.1.10. RECHARGING, fig.8, see also Section 8 6.1.10.1. Recharge the Roadstart immediately after use. fig.8 fig.7 Original Language Version © Jack Sealey Limited...
  • Page 5: Reverse Polarity

    1. By connecting the red clamp (+) to the negative terminal of the battery and black clamp (-) to the vehicle’s chassis, fig.11. THE REVERSE POLARITY SIGNAL WILL NOT OPERATE BECAUSE THIS IS NOT A REVERSE POLARITY. fig.11 Original Language Version © Jack Sealey Limited PBIW4600, PBIW6200 | Issue:2 (6) 04/11/19...
  • Page 6: Risk Of Explosion

    8.2.6. Charged/Maintaining LED (green) pulsing: The Roadstart battery is fully charged. The charger moves into float charging mode to maintain the battery capacity. 8.2.7. Reverse polarity LED (red) flashing: not applicable as Roadstart has a charging plug. Original Language Version © Jack Sealey Limited...
  • Page 7: Troubleshooting

    BATTERY REMOVAL Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.

This manual is also suitable for:

Pbiw6200