Advertisement
6.1.2.2.
24V JUMP STARTING
NOTE: Read point 6.2 detection of 24V
IF THE BATTERIES ARE SIDE BY SIDE, fig.3
Connect the red clamp (+) to the positive terminal (+) of the battery, then connect the Black clamp (-) to the negative (-) terminal of the
other battery.
IF THE BATTERIES ARE ON BOTH SIDES OF THE VEHICLE, fig.4
Connect the Red clamp (+) to the positive terminal (+) of the battery, then connect the black clamp (-) to the negative terminal (-) or to
the mass of the vehicle.
fig.3
6.1.3.
VOLTAGE SELECTION, fig.5
6.1.3.1.
Select the correct voltage, for the vehicle to be jump started.
NOTE: From this moment on there is voltage to the clamps.
6.1.4.
START THE ENGINE
6.1.4.1.
Turn the ignition key for a maximum of 3 - 8 seconds. Wait for a further minute before attempting to start again.
fig.5
6.1.5.
DISCONNECTION, fig.6
6.1.5.1.
Disconnect the black (-) clamp first followed by the red (+) clamp.
6.1.6.
DISCONNECTION OF THE VOLTAGE SELECTOR, fig.7
6.1.7.
After starting disconnect the voltage selector.
6.1.8.
STORAGE, fig.7 see also Section 7
6.1.9.
Return the clamps to their support posts.
6.1.10.
RECHARGING, fig.8, see also Section 8
6.1.10.1. Recharge the Roadstart immediately after use.
fig.7
© Jack Sealey Limited
fig.4
fig.6
fig.8
Original Language Version
Advertisement
