Related Manuals for Sealey ROADSTART PBI2212GS
Summary of Contents for Sealey ROADSTART PBI2212GS
- Page 1 ROADSTART® EMERGENCY JUMPSTARTERS DEKRA APPROVED : PBI2212GS, PBI4424GS MODEL NO’S PBI2212GS, PBI4424GS ISSUE 3 (SP) 09/04/19 0099001871-01...
-
Page 2: Specification
INTRODUCTION Manufactured with professional grade, high performance AGM battery, produced in the USA and specially formulated to jump start vehicles. The only range of DEKRA approved emergency jump starters on the market. Supplied with automatic maintenance charger that features patented microprocessor controlled speed charging, with thermal runaway protection. - Page 3 PLEASE SAVE THIS OWNER’S MANUAL AND READ BEFORE EACH USE. This manual will explain how to use the unit safely and effectively. Please read and follow these instructions and precautions carefully. IMPORTANT: READ AND SAVE THIS SAFETY AND INSTRUCTION MANUAL SAVE THESE INSTRUCTIONS –...
- Page 4 1. IMPORTANT SAFETY INSTRUCTIONS – SAVE THESE INSTRUCTIONS This manual contains important safety and operating instructions. RISK OF ELECTRIC SHOCK OR FIRE. 1.1. Read the entire manual before using this product. Failure to do so could result in serious injury or death.
-
Page 5: Personal Precautions
2. PERSONAL PRECAUTIONS RISK OF EXPLOSIVE GASES. A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLOSION. TO REDUCE THE RISK OF A SPARK NEAR THE BATTERY: 2.1. NEVER smoke or allow a spark or flame in the vicinity of a battery or engine. 2.2. - Page 6 3.4. Make sure that the Roadstart® cable clamps make tight connections. 4. FOLLOW THESE STEPS WHEN CONNECTING TO A BATTERY A SPARK NEAR THE BATTERY MAY CAUSE A BATTERY EXPLOSION. TO REDUCE THE RISK OF A SPARK NEAR THE BATTERY: 4.1.
- Page 7 1. Heavy-duty battery clamps 2. Display button 3. Digital display 4. USB button 5. USB Port 6. Booster ON/OFF switch – 0 or 12V position for Model 12V / 0 or 12V or 24V position for Model 12/24V 7. 12V DC socket 8.
- Page 8 6.1.2 LED Indicators on the Charger POWER (green) LED lit: The charger is connected to AC power. CHARGING (yellow/orange) LED pulsing slowly: The charger is charging the battery inside the booster or is in maintaining mode. CHARGING (yellow/orange) LED flashing rapidly: The charger has detected a problem with the battery.
- Page 9 When the display on the Roadstart® shows 100 (%), the internal battery is fully charged and the Roadstart® is ready to use. Complete charging may take up to 24 hours. NOTE: The yellow CHARGING LED on the charge will remain flashing after display shows 100%, because charger enters automatically into maintaining mode.
-
Page 10: Maintenance Instructions
4. Turn the USB device on. 5. Reverse these steps when finished using the USB port. NOTES: The USB port will shut-off automatically after 60 minutes, if no device is connected. Extended operation of a USB device may result in excessive battery drain. Recharge the Roadstart® immediately after unplugging the device. -
Page 11: Troubleshooting
11. TROUBLESHOOTING PROBLEM POSSIBLE CAUSE REASON/SOLUTION The Roadstart® Clamps are not making a good Check for poor connection to battery and won’t jump start my connection to the battery. frame. Make sure connection points are car. clean. Rock clamps back and forth for a better connection. -
Page 12: Environment Protection
BAttERy REmovAl Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705. -
Page 13: Ec Declaration Of Conformity
2011/65/EU RoHS Directive This declaration of conformity is issued under the sole responsibility of the manufacturer: Jack Sealey Ltd, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR Declaration of Conformity in accordance with the above Directive(s)� References to harmonised standard(s) EN 55014-1:2006+A1:2009+A2:2011 �������������������������������������������... - Page 14 IMPORTANT: No liability is accepted for incorrect use of product. WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 01284 703534 sales@sealey.co.uk...
- Page 15 IMPORTANT: No liability is accepted for incorrect use of product. WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 01284 703534 sales@sealey.co.uk...