Download Print this page

Troubleshooting; Environment Protection - Sealey PBIW4600 Manual

Schumacher 500/1500hp 12/24v wheeled roadstart emergency jump starter

Advertisement

9. TROUBLESHOOTING

PROBLEM
The Roadstart won't jump start car.
Roadstart will not power 12V device.
The battery in the Roadstart won't hold a
charge.
The green POWER LED does not light
when charger is properly connected.
The red BATTERY DEFECT LED is lit and
yellow/orange CHARGING LED is flashing
rapidly.

ENVIRONMENT PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance scheme. Jack
Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
POSSIBLE CAUSE
Clamps are not making a good connection
to the battery.
The Roadstart battery is not charged.
The vehicle's battery is defective.
The fuse has blown.
The 12V device is not turned on.
The 16A fuse has been triggered.
Roadstart battery is not charged.
The battery is bad (will not accept a
charge).
mains outlet dead.
Poor electrical connection.
The battery voltage is still under 10V after
2 hours of charging.
(or)
In maintain mode, the output current is
more than 1.5A for 12 hours.
Desulphation was unsuccessful.
01284 703534
sales@sealey.co.uk
Original Language Version
REASON/SOLUTION
Check for poor connection to battery and
chassis. make sure connection points are
clean. Rock clamps back and forth for a
better connection.
Check the battery charge status by
pressing the button on the front of the
Roadstart.
Have the battery checked.
Replace the power fuse.
Turn on the 12V device.
Push the 16A fuse button to turn it back
on, see 4.1 point 2.
Check the battery charge status by
pressing the button on the front of the
Roadstart.
Have the battery checked.
Check for open fuse or circuit breaker at
the supplying AC outlet.
Check power cord and extension cord for
a loose fitting plug.
The battery may be defective. make sure
there are no loads on the battery. If there
are, remove them. If there are none, have
the battery checked or replaced.
The battery may be defective. Have it
checked or replaced.
www.sealey.co.uk
PBIW4600, PBIW6200 | Issue:2 (6) 04/11/19

Advertisement

loading

This manual is also suitable for:

Pbiw6200