Toro 30622 Installation Instructions

Premium Seat Kit
Groundsmaster
Model No. 30622
1. Position the machine on a level surface, lower the
cutting units, stop the engine, engage the parking
brake and remove the key from the ignition.
2. Place the seat onto the seat suspension, aligning the
mounting holes in the seat rails with the holes in the
top of the suspension. Use the holes indicated in
figure 1.
1
3
4
2
Figure 1
1. Premium seat
2. Seat suspension
3. Loosely attach the seat/slide rail assembly to the seat
suspension with (3) M8 x 12 screws and (1) M8 x 16
screw. The M8 x 16 is to be used in the forward left
hole.
GM 4000 series only
• Torque the screws to 18 ft–lb (25 N
m). The rail
stop is not required.
GM 580–D only
• Tighten all (4) screws securely but do not torque.
• Slide the seat completely forward.
W 2008 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
)
580–D, 4000–D & 4100–D
3. Torx screw (3)
4. Rail stop (GM 580–D only)
Installation Instructions
• Remove the (3) #25 Torx screws securing the seat
cushion to the front of the seat pan (Fig. 1).
Remove the seat cushion.
• Remove the nut and bolt securing the front of the
left seat rail to the seat pan.
• Remove the M8 x 16 screw securing the front of
the left seat rail to the suspension.
• Slide the seat completely rearward and insert the
rail stop (Fig. 1) into the slide rail until the holes
align.
• Secure the rail stop to the slide rail and suspension
with the M8 x 16 screw previously removed.
• Torque all the screws to 18 ft–lb (25 N
m).
• Slide the seat completely forward and secure the
front of the left seat rail to the seat pan with the nut
and bolt previously removed. The nut and bolt
should stop the seat when moved rearward.
• Install the seat cushion to the seat pan and secure
with the (3) #25 Torx screws previously removed.
4. Mount the retractor side of the seat belt assembly to
the left side of the seat as follows:
GM 4000 series only
• Secure the seat belt mount to the seat belt retractor
with a 7/16 x 1 in. button head screw, washer and a
nut, as shown in figure 2.
• Torque the screw to 55 ft–lb (75 N
m).
• Secure the seat belt mount to the left side of the
seat with a 7/16 x 1–1/4 in. capscrew, lock washer
and (2) flat washers (Fig. 2).
• Torque the screw to 55 ft–lb (75 N
m).
Note: One of the flatwashers is to be positioned between
the seat belt mount and the seat.
GM 580–D only
• Secure the belt retractor directly to the left side of
the seat with a 7/16 x 1–1/4 in. capscrew, lock
washer and (2) flat washers (Fig. 2). The seat belt
mount is not required.
• Torque the screw to 55 ft–lb (75 N
m).
Note: One of the flatwashers is to be positioned between
the seat belt mount and the seat.
1
Form No. 3352–451 Rev A
All Rights Reserved
Printed in the USA