Philips 9000 Series Manual page 22

22
English
Always replace the shaving heads with original Philips shaving heads
(see 'Ordering accessories').
Replacement reminder
The replacement reminder indicates that the shaving heads need to
be replaced. The shaving unit symbol lights up continuously, the
arrows flash white and you hear a beep when you switch the shaver
on or off (Fig. 79).
1 To replace the shaving heads, remove the shaving heads from the
shaving head holder one by one. See chapter Thorough Cleaning
for the instructions on how to remove the retaining rings and
shaving heads.
Note: The shaving heads are locked by a blue (Fig. 56) or an
orange (Fig. 57) retaining ring. Follow the correct instructions.
2 To reset the replacement reminder, press and hold the on/off
button for approx. 7 seconds (Fig. 80). Wait until you hear two
beeps.
Replacing the cleansing brush attachment
The cleansing brush attachment should be replaced (Fig. 75) every 3
months or earlier if the brush hairs are bent or damaged (see
'Ordering accessories').
Ordering accessories
To buy accessories or spare parts, visit
www.shop.philips.com/service or go to your Philips dealer. You can
also contact the Philips Consumer Care Center in your country (see
the international warranty leaflet for contact details).
The following accessories and spare parts are available:
- SH90 Philips shaving heads
- HQ110 Philips shaving head cleaning spray
- RQ111 Philips beard styler attachment
- RQ585 Philips cleansing brush attachment
- RQ560/RQ563 Philips cleansing brush heads
- JC301/JC302/JC303/JC304/JC305 cleaning cartridge
- HQ8505 supply unit