Philips 9000 Series Manual page 18

18
English
Replacing the cartridge of the SmartClean system
Replace the cleaning cartridge when the replacement symbol flashes
orange or when you are no longer satisfied with the cleaning result. If
you clean the shaver in the SmartClean system once a week, the
SmartClean cartridge lasts approximately three months.
1 While holding the SmartClean system with one hand, press the
button on the side of the SmartClean system and lift the top part
of the SmartClean system.
2 Remove the cleaning cartridge from the SmartClean system and
pour out any remaining cleaning fluid (Fig. 51).
You can safely pour the cleaning fluid down the sink.
3 Discard the empty cleaning cartridge.
4 Unpack the new cleaning cartridge and pull off the seal (Fig. 44).
5 Place the cleaning cartridge in the SmartClean system (Fig. 45).
6 While holding the SmartClean system with one hand, gently push
the top part of the SmartClean system back down ('click') (Fig. 46).
Cleaning the shaver under the tap
Clean the shaver after every shave for optimal performance.
Be careful with hot water. Always check if the water is not too hot,
to prevent burning your hands.
Never dry the shaving unit with a towel or tissue, as this may
damage the shaving heads.
1 Switch on the shaver.
2 Rinse the shaving unit under a warm tap (Fig. 23).
3 Switch off the shaver. Pull the shaving head holder off the bottom
part of the shaving unit (Fig. 52).
4 Rinse the hair chamber under the tap (Fig. 53).
5 Rinse the shaving head holder under a warm tap (Fig. 54).
6 Carefully shake off excess water and let the shaving head holder
air-dry completely.
7 Attach the shaving head holder to the bottom part of the shaving
unit ('click') (Fig. 55).