Toro Groundsmaster 360 Installation Instructions page 4

Figure 4
1. Seat plate
2. Control panel
6. Install the control panel with the button-head screws
previously removed.
7. Plug the fuse block connector on the wire harness into
the fuse block and plug the ground block connector
into the ground block
Figure 5
1. To the ground block
2. To the fuse block
8. Plug the remaining harness connector into the
differential lock valve located under the center of the
seat plate (Figure 6).
3. New wire harness
(Figure 5).
3. To the differential lock
valve
1. Harness connector
9. Disengage the seat latch and lower the seat.
10. Press the front of the switch and hold it down to
engage the differential lock.
4
Completing the Installation
No Parts Required
Procedure
1. Connect the positive battery cable to the positive post
of the battery; refer to the Operator's Manual for your
machine.
WARNING
Incorrect battery cable routing could damage
the machine and cables causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative
(black) cable.
2. Connect the negative cable from the battery post; refer
to the Operator's Manual for your machine.
4
Figure 6
2. Harness clip