Toro 74946 Software Manual page 12

Calibrate Engine Settings
This screen allows the calibration of the actual engine
speed to match the commanded engine speed.
The enter button blacks out if the blades are not
disengaged, the parking brake is not engaged, and
the motion-control levers are not in the N
position. Once they are, press the Enter button to
start the calibration process.
1. Calibrate Engine Settings
An animated hourglass appears indicating the
calibration is in process.
1. Calibrate Engine Speed
2. Calibrating
Once the calibration is complete, you can toggle back
to the primary Calibrate Engine Speed screen.
1. Calibration Engine Speed
2. Calibration Complete
EUTRAL
Figure 35
2. Start Calibration
Figure 36
3. Processing
Figure 37
3. Toggle between screens
Factory Defaults
This screen allows you to reset system settings back
to the factory default settings. Pressing the Enter
button brings up confirmation screen; press Y (yes) to
reset or N (no) to cancel.
-L
OCK
Note:
Resetting the system returns the engine speed
settings and alarm settings back to the factory default
settings.
g030234
1. Factory Defaults
When the exit screen appears, press the enter button
to go back to the Menu Selection screen.
Returning to the Default
Screen (Engine-On or
Engine-Off)
There are 3 ways to return to the default screen:
•
Press the previous or next arrow keys until the
g030235
Exit screen appears then press the Enter button to
return to the Menu Selection screen.
•
Turn the ignition key to the O
either restart the engine or turn the key to the O
position.
•
Press and hold the 2 outside buttons.
Setting Engine Speeds
At startup, the system defaults to the Low engine
speed. The icon on the information screen is
highlighted.
•
Press the button below the Efficient Speed Mode
icon to increase the engine speed to the Efficient
engine speed.
g030237
The Efficient Speed Mode icon is highlighted.
•
Press the button below the Maximum Speed Mode
icon to increase the engine speed to the maximum
engine speed.
The Maximum Speed Mode icon is highlighted.
Note:
If you engage the PTO switch at any speed
setting, the engine speed ncreases to the mow speed.
12
Figure 38
2. Reset
position and
FF
g030238
N