Engine Settings - Toro 74946 Software Manual

Alarms
The alarms screen allows you to activate and
deactivate the audible alarm for individual errors.
Press the Enter button to access individual error alarm
settings.
Note:
Not all audible alarms can be deactivated.
1. Alarms
2. Activate/Deactivate
The highlighted error name indicates that the audible
alarm is active. Pressing enter modifies the status of
the audible alarm to On or Off.
1. Alarms
2. Clutch Overcurrent
3. Fuel Low
You can deactivate the audible warning for the
following errors:
•
Service Air Filter
•
Service Engine Oil
•
Service Transmission Oil
•
Service Gear Box Oil (as applicable)
•
Fuel Low
•
Clutch Overcurrent
•
Clutch Reset Required
•
Engine Error Codes
•
System Overvoltage>16VDC
•
System Undervoltage<9VDC
•
System Voltage Low
Figure 31
3. Audible Alerts
4. Enter
Figure 32
4. Toggle
5. Enter

Engine Settings

This screen allows you to adjust the engine speed
at the Maximum, Efficient, and Low set points for
both transport (clutch disengaged) and mow (clutch
engaged) modes in 50 rpm increments.
g030225
1. Engine Settings
Pressing the up arrow increases the engine speed
while pressing the down arrow decreases the engine
speed. Pressing the Enter button confirms the
speed and automatically moves you to the next
screen/engine speed set point.
g038366
1. Engine Settings
2. Set Low Mow Speed
3. Engine speed in rpm (e.g.
3600)
The system does not allow the following to occur:
•
The efficient speed cannot be set higher than the
maximum speed.
•
The low speed cannot be set higher than the
efficient speed.
Note:
You can set the maximum speed equal to the
efficient mow speed to use the efficient mode while
mowing.
11
Figure 33
2. Adjust Engine Speeds
Figure 34
4. Up arrow—Increase
5. Enter
6. Down arrow—Decrease
g030227
g030228