Table of Contents
Advertisement
Installing an RTN 360
Equipment Components
A
Appearance and ports
Front view
Port GE(e)
Port P&E (receives both
services and power signals)
Maintenance
compartment
Rear view
Ground screw
04/05 >>
B
Mounting kits
Interior of the maintenance
compartment
6
RSSI/NMS port
USB port
5
1.
Holes for mounting to a wall or pole (four holes)
2.
Adjustment locking screw
3.
Elevation adjustment wing nut
4.
RTN 360 mounting bracket
5.
Adjustment locking screw
6.
Azimuth adjustment wing nut
Holes for mounting an
alignment scope
C
Hose clamp
The attachment plate is installed
before delivery.
•A hose clamp is used to install an RTN 360 on a pole. Choose a hose
clamp of a proper size based on the diameter of the pole.
•If you find that the hose clamps are too long after completing the
installation, fasten the extra portion of the hose clamps onto the pole
using outdoor binding straps.
D
USB flash drive
1
2
3
• The recommended USB flash drive is a 4 GB Netac U208. If a
different model or capacity is required, contact the local Huawei
office to verify compatibility. USB flash drives not meeting
requirements may be incompatible.
• Only USB 2.0 is supported.
• The appearance of the shipped USB flash drive may differ from
4
that shown here.
E
Alignment scope
Lens
Mounting
frame
Mounting
loop
Eyepiece
Advertisement
Table of Contents
