Huawei RTN 360 V100 Quick Installation Manual page 11

References for Installation
Powering On an RTN 360
On an RTN 360, only port P&E supports power over Ethernet.
B20 PI
GE1 P&E1
To the
wireless
equipment at
the opposite
end To the RTN 360
External power
supply equipment
A GE port on the PI connects to the peer wireless device. P&E ports
connect the RTN 360s and PI. For details about how to install a PI and
cables, see the OptiX RTN PI-AC B20 Product Overview and
Installation Guide.
20/21 >>
Before powering on the equipment, ensure that:
•The P&E cable and the PI power cable are installed.
•DIP switches are set correctly, and the DIP switch for setting the power over ethernet mode for the used P&E port is turned to the PSE-PD side. After setting the DIP switches, switch off the power supply. After
waiting for 6 seconds, switch on the power supply again.
• Power on the equipment within 24 hours of unpacking.
• During maintenance, the power-off time of the equipment cannot be longer than 24 hours.
RTN 360
Remove plugs from the cable trough and fix outdoor network
cables within the PI using a crimp.
Clip
Wireless equipment at the
opposite end
RTN 360
RTN 360
External power
supply equipment
Port GE1, which is connected to the wireless
equipment at the opposite end
Port P&E1, which is connected to one
RTN 360
Port P&E2, which is connected to the
other RTN 360
B20 PI
Wireless equipment at the
opposite end