Opening The Crate; Removing The Machine From The Crate - Toro Z Master 8000 Series Setup Instructions

Procedure
9
10
11
12
13
1

Opening the Crate

No Parts Required
Procedure
1. Lower the ends of the crate.
2. Remove the retaining straps.
3. Remove the plastic ties around the hopper
handles.
Description
No parts required
No parts required
No. 2 lithium grease (Purchase
separately.)
No parts required
Operator's Manual
Engine owner's manual
Registration card
Operator training material
Key
Qty.
–
Charge the battery.
–
Check the hydraulic Fluid.
1 tube Check the machine for grease.
Check the machine before delivery to
–
the customer.
1
1
1 Deliver the machine to the customer.
1
2
2
Removing the Machine
from the Crate
Parts needed for this procedure:
1 Rear caster wheel
1 Bolt (1/2 x 13 inches)
1 Locknut (1/2 inch)
Driving the Machine Off the Crate
CAUTION
The mower deck is shipped in the Up position,
but it is not latched. Removing shipping
reinforcements without supporting the front
of the deck causes the deck to drop, which
may result in injury or property damage.
Always securely support the front of the deck
while setting up the machine.
Note:
Ensure that the discharge tube does not catch
on the crate when driving the machine off the crate
(Figure 4).
1. Remove the rear caster-wheel assembly from
inside the hopper.
2. Remove the bolt holding the rear-frame support
to the frame (Figure
2
Use
1).