Sc750-65; Perfect Binder: Cut End Late Error - Ricoh Pro 8300S Troubleshooting Manual

Blade sensors 1, 2 defective

 Motor/sensor disconnected
Overload

Solution
Reconnect the connector.

 Replace the cutter motor.
Replace the blade sensors 1, 2.

Replace the cutter control board.

Replace the motor harness.

Replace the sensor harness.


SC750-65

Error Name

Perfect Binder: Cut End Late Error

Pattern
D
Error Condition
When moving from front to rear during cutting, blade sensor 1 does not go ON after enough time

has elapsed for the blade to move 61 mm.
When moving from front to rear during cutting, blade sensor 1 does not go ON after 10 sec. have

elapsed.
Major Cause
Cutter motor defective

Blade sensors 1 defective

Motor/sensor disconnected

 Overload
Blade is dull and not cutting efficiently.

Solution
Reconnect the connector.

Replace the cutter motor.

Replace the blade sensors 1.

Replace the cutter control board.

 Replace the motor harness.
Replace the sensor harness.

 Replace the blade.
1.SC Codes
345