Sc672-00, 10, 11, 12, 13; Controller Start Up Failure - Ricoh Pro 8300S Troubleshooting Manual

1.SC Codes
Slave VODKA reset

 CPU reset due to hardware defect / noise
Slave VODKA reset due to hardware defect / noise

Major Cause
Engine board was reset unexpectedly.
Solution
1. Turn the main power OFF and ON 10 times, and check if the SC occurs more than once.
2. Check the machine and controller firmware version.
If there is a newer version, update the firmware.
3. Check the connection of the engine board and the controller board.
4. Disconnect/reconnect the harness between the engine board and the controller board.
5. Replace the BiCU.
6. Replace the PSU.
7. Replace the controller board.

SC672-00, 10, 11, 12, 13

Error Name

Controller Start Up Failure

672-00

 672-10
672-11

672-12

672-13

Pattern
D
Error Condition
Communication between controller and operation panel does not commence normally at power

ON.
Communication with controller was cut off even though start up was normal.

No attention code (FDH) / attention acknowledge code (FED) from the controller 30 seconds after

operation panel power On reset.
Communication check command was issued from the operation panel once every 30 seconds, but

there was no response from the controller for two consecutive times. There is no SC logging and
CSS report because this was detected by the operation panel.
200