quadient IS-300 Series Product Replacement Manual

IS-300 Series Base
Product Replacement Guide
Machine components:
Machine Base
Feed Table
N1. Remove the components from your original machine
1
Remove the Feed Table (a) by lifting the machine
(b) slightly and sliding the Feed Table downwards
to unlock
6 6
Disconnect the Power Cable (d) from the right hand
side of the machine
The machine must be disconnected from the
power supply before continuing to the next step!
Average Time Required: 20 minutes
LAN Cable
Power Cable
2
Lift the top cover to reveal Ink Cartridge (e)
and Meter (f) compartment
7
Open the door of the compartment situated to the
left of the Ink Cartridge (e) to reveal the Meter (f)
Ink Cartridge Meter
3
Press down on the Cartridge (e) below the word
'TOP' until you hear a 'click'
8
Slide the Meter (f) towards you
Removal
Installation
4
Remove the Ink Cartridge (e) and close the
machine cover
9
Remove the Meter (f)
Please do not connect your replacement
machine to the power until step N6
5
Disconnect the LAN Cable (c) from the left hand
side by pressing and holding down the clip
N2. Unpack your replacement
1
Remove replacement unit from box & place
original unit back into box ready for collection
Caution: Product weighs 10.8kg,
please seek assistance before lifting