Toro 04119 Installation Instructions

Out Front Brush Kit
Greensmaster 800, 1000 & Flex 21
Model No. 04119
1. Position the machine on a level surface. Stop engine.
Note: Steps 2 thru 6 pertain to the Greensmaster Flex
21 only. Steps 7 thru 12 pertain to the Greensmaster
800/1000 only. All remaining steps pertain to all.
2. Remove the capscrew and washer securing the left end
of the front frame to the tab on top of the cutting unit
(Fig. 1).
1
Figure 1
1. Front frame
3. Mount a L.H. brush bracket to the front frame and tab
with the M10–1.5 x 30 capscrew and washer
previously removed (Fig. 2).
Figure 2
1. Brush bracket (L.H.)
2. Hole
3. Level adjustment screw
W 2003 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Flex 21
4
3
1
2
5
Flex 21
4. Jam nut
5. Locknut
Installation Instructions
Note: The bracket is to be positioned so the hole in the
bottom is to the front. The bracket should fit over the end
of the front frame and tab.
4. Loosely mount the level adjustment screw to the brush
bracket with a jam nut and a lock nut (Fig. 2).
5. Mount a brush spring and brush rod to the brush
bracket with (2) 1/4–20 x 1–1/2" lg. capscrews,
spacers and lock nuts (Fig. 3).
3
Figure 3
1. Brush bracket (L.H.)
2. Brush spring
6. Repeat the procedure on the opposite side of the
machine.
7. Remove (2) capscrews and washers securing grass
catcher mounting rod to left sideplate (Fig. 4).
Figure 4
1. Grass catcher mounting
rod
8. Resecure the grass catcher mounting rod to the left
sideplate with (2) new fully threaded 5/16–18 x 1–1/2"
lg. capscrews and the (2) washers that were previously
removed (Fig. 5).
1
Form No. 3355–228 Rev A
1
2
4
Flex 21
3. Brush rod
4. Spacers (2)
1
GR 800 & 100
All Rights Reserved
Printed in the USA