Advertisement
Red (+)
E/START
Black (-)
Clamp (-)
fig.9
5.7.2.
connect e/stArt to the vehicle with the battery lead disconnected from the battery, PositiVe e/stArt lead connected to
VEHICLE BATTERY POSITIVE lead,see fig.9.
5.7.3.
Press the on/off for a few seconds to activate oVerride mode.
5.7.4.
turn on the engine.
5.7.5.
Put the PositiVe e/stArt leAd and VeHicle BAtterY PositiVe onto the BAtterY PositiVe terminAl. remove the
E/START's POSITIVE lead after it is fastened to the battery terminal, see fig.10.
Red (+)
E/START
Black (-)
fig.10
5.8.
GLOW MODE (Only use if the glow plug symbol appears on the vehicle instrument panel)
5.8.1.
In cold weather the glow plugs in most diesel vehicles will be first energised to heat up the engine before it is started, as indicated by a
symbol on the instrument panel.
5.8.2.
if this is the case, after the e/stArt is fully recharged and connected to the vehicle, press GloW button and turn on the ignition.
note: GloW is inActiVAted in oVerride mode (5.3.3 above).
5.9.
LED WORKING LIGHT
5.9.1.
Press the light button to turn on/off.
5.10.
RECHARGE BACKuP BATTERY
5.10.1.
use the micro usB or the 12V accessory cable to recharge the back up battery after each use or once a year.
6. MAINTENANCE
6.1.
replace battery pack by unscrewing door on rear of e/stArt and disconnect wiring plug.
Parts support is available for this product. to obtain a parts listing and/or diagram, please log on to
Note: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
ENVIRONMENT PROTECTION
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGuLATIONS
dispose of this product at the end of its working life in compliance with the eu directive on Waste electrical and electronic equipment
(Weee). When the product is no longer required, it must be disposed of in an environmentally protective way. contact your local solid
waste authority for recycling information.
BATTERY REMOVAL:- unscrew battery door on rear unplug battery and remove.
under the Waste Batteries and Accumulators regulations 2009, Jack sealey ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance scheme. Jack
sealey ltd Batteries Producer registration number (BPrn) is BPrn00705.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack sealey limited
Clamp (-)
www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500
01284 703534
Original Language Version
Clamp (+)
Clamp (+)
sales@sealey.co.uk
www.sealey.co.uk
e/stArt800HY | issue:2 21/07/17
Advertisement
